Відео

Great video. What meter do you use?

thanks for your help but please speak slowly 😅

You have to be a shady sales person in this trade to make a six figure income.

The startup guys around here turn it on and for the hills. That's for all equipment, boilers, chillers, etc. Good times.

Good stuff !!

It is nice when you can run a system fully loaded long enough to tune and adjust it properly.

HVAC Manufacture: “Here’s the unit you ordered.” HVAC Tech: “It’s not working correctly.” HVAC Manufacture: “Sounds right, and it’s your fault.” HVAC Tech: “…”

Great video. Thank you for sharing

Why would you risk voiiding the warranty by messing with the settings? You could have just called back the factory rep to do it for free.

On-the-fly tuning doesn't give me all the warm and fuzzy feelings when I'm starting up a chiller. I

Hello sir my Trane compressor Overlord error coming why I m technician what to do

Good

Great video and thank you for sharing your knowledge. Do you teach a course related to building automation for hvac on your website? Thanks in advance.

Great video. Thank you for sharing

What’s the resistance range when ohming out the solenoid? I’m troubleshooting a circuit doing the opposite, won’t load up. Help me Batman. ❤

My HVAC teacher called it a ‘No Name Line.’

11:30 also because greater lift requirements for other refrigerants like r134a found in YK 's

Great exercise. More videos like these. 👍

I remember this call. I thank you for the help. It was a fun one

If you sucked the data out of the pco you could put it into 1tool and see how it is cofigured. Just abit of a pain tho

Hi My friend!

Amazing! Thank you for sharing! I work as a controls electrician dealing with BAS equipment! It’s always fascinating to see such old pneumatic HVAC controllers still in action!

Chiller Community & Chiller Training: chilleracademy.com

Do you know where that brand is from ? Cause that electrical panel definitely looks European, that's the typical ones you'll find over here .

Yes very difficult job,it takes time I did residential and commercial building , it’s been 35 years

I'd be inclined to just get some name brand transducers off the shelf that you have a data sheet for, seems like you've got all the scaling and offsets under control to make any half decent transducer work! What was the actual problem there though? Sounded like... they were having issues, swapped the sensors, still having issues, then went back to the original sensors and settings and it was fine?

Good job troubleshooting video

Great work Batman! I’ve learned to never trust system sensors until they’ve been verified for accuracy. Wild to see how many problems can occur from sensors reading improperly. That plant looked so clean! What kind of equipment were they feeding the chilled water to?

Thank you very much indeed for such a detailed and informative explanation.

In most areas of this country you will not make over 75,000.00 per year unless you are willing to lie , cheat and steal.

Question: Is it typical for a screw compressor often to have low oil problem? I’ve seen this in McQuay, Dunham Bush and Trane.

Thanks For showing how to work on a Ace chiller

COMPRESSIVE....Sparkle Word of the Day...👍

❤

3:41 Maybe global warming? Keeping up with hotter climates as our shield degrades?